 |
|||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|||||||
Bacteria Destroying UV System - AquaPure
go to American Plumber reverse osmosis systems - go to Drinking Water Solutions (KISS) reverse osmosis systems
"Is there anything I should do before installing an ultraviolet filter system??"
Before installing any UV (brand) unit, we think it a good idea to
start with a clean system (water lines, water heater, etc.). It's best to disinfect the entire downstream system with chlorine (caution, too much chlorine can damage your
pipes) or other disinfectant that is safe for piping and humans. Micro-organisms will continue to thrive unless you take the time to start with a clean system.
"I just installed a new filter cartridge and my water is cloudy/white?"
After you install a new filter (this is the case with any/all brands of filter cartridges)
you should run it for a few minutes. Generally cloudy or white water indicates air in the line and this is natural and normal with a replacement of a cartridge. Air will
enter in the housing, lines and cartridge. Just run the water for a few minutes and the cloudy conditions will go away (unless you have VERY cold water in which case it is
the oxygen in the water that could be making the water look cloudy). It is always a good idea to run the water free flowing for a few minutes after installing any brand or
type of new filter cartridge.
"Does a UV system require any chemicals or anything else that I have to add??"
Most manufacturers recommend that you use a 5 micron (or
smaller) sediment filter before a UV unit (problem with a small 5 micron is the flow rate is reduced significantly and we recommend that if you buy our 5 gpm Jumbo filters
to buy the 20" double models which will normally provide enough volume for the 12 gallons per minute rating). This is required because large particles provide a haven for
microorganisms that you are trying to destroy. Depending on the turbidity of the water, multiple sediment filters may also be required before the UV system. If color or
suspended particles are present, the transmission quality of any UV light is diminished and its disinfecting properties are then limited. Where this is a problem, a quality
carbon filter may be needed after the sediment filter and before the UV unit.
"What is a micron rating?"
The average size of the openings between pieces of the filter media are represented in microns. For
example, a 40-micron filter has larger openings than a 5-micron filter. Consequently, the 40-micron filter element will let larger particles pass through the filter than
the 5-micron element.
read many interesting quotes, such as:
"When wealth is lost, nothing is lost; when health is lost, something is lost; when character is lost, all is lost."
- Billy Graham
Alphabetical Product Listing: A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Copyright © 1995-2010. PlumbingStore.com |
|